Welcome to our online shop!

Popular Brands

Items 1 to 20 of 732 total

Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

List  Grid 

Set Descending Direction
  1. 1 Inch Return Female Spinning Wave outlet Out Flow System

    1 Inch Return Female Spinning Wave outlet Out Flow System Learn More
    $13.50

  2. 1" 25mm Inch Return Male Spinning Wave outlet Out Flow System

    One Inch Return Male Spinning Wave outlet Out Flow System Learn More
    $13.50

  3. Aqua Medic Aqua Smoothy

    Aqua Medic MICROFIBER GLASS CLOTH

    Superfine micro porous fibre cloths, for smear free cleaning of the outside glass of the aquarium, lint-free. The aqua smoothy is very absorbent and can be used either wet or dry. It will safely and gently remove salt encrustation or fatty residues without the use of aggressive cleaning agents. Can also be used on most other smooth surfaces.
    Contents: 2 x cloths, each approximately 40 x 40 cm
    Microfiber: 80 % polyester, 20 % polyamide.

    Learn More
    $11.93

  4. Aqua Medic DC Runner 1.1 controllable pump 1200lph

    High performance low voltage (24v DC) circulation pump for freshwater and saltwater aquariums complete with DC Controller.

    • 2 Year Warranty
    • Power saving DC motor offers high efficiency operation.
    • The DC Controller allows 8 levels of flow adjustment and also a 10 minute Feeding mode.
    • DC Runner pumps can be used submersed or non submersed.
    • 0-10volt outlet for connection to popular external controllers
    • Soft start for less stress on the impeller and electronics.
    • Transparent pump housing to easily view cleanliness of impeller and pump chamber.
    • Run dry protection cuts in after 2 minutes if no water flow is detected.
    Learn More
    $159.05

  5. Aqua Medic DC Runner 2.1 controllable pump 2000lph

    High performance low voltage (24v DC) circulation pump for freshwater and saltwater aquariums complete with DC Controller.

    • 2 Year Warranty
    • Power saving DC motor offers high efficiency operation.
    • The DC Controller allows 8 levels of flow adjustment and also a 10 minute Feeding mode.
    • DC Runner pumps can be used submersed or non submersed.
    • 0-10volt outlet for connection to popular external controllers
    • Soft start for less stress on the impeller and electronics.
    • Transparent pump housing to easily view cleanliness of impeller and pump chamber.
    • Run dry protection cuts in after 2 minutes if no water flow is detected.
    Learn More
    $199.99

  6. Aqua Medic DC Runner 5.1 controllable pump 5000lph

    High performance low voltage (24v DC) circulation pump for freshwater and saltwater aquariums complete with DC Controller.

    • 2 Year Warranty
    • Power saving DC motor offers high efficiency operation.
    • The DC Controller allows 8 levels of flow adjustment and also a 10 minute Feeding mode.
    • DC Runner pumps can be used submersed or non submersed.
    • 0-10volt outlet for connection to popular external controllers
    • Soft start for less stress on the impeller and electronics.
    • Transparent pump housing to easily view cleanliness of impeller and pump chamber.
    • Run dry protection cuts in after 2 minutes if no water flow is detected.
    Learn More
    $310.30

  7. Aqua Medic Ozone 300

    Aqua Medic Ozone 300

    ozone 300 for injection of ozone into the water can improve the efficiency of protein skimming and raise the ORP (redox potential). The decomposition of toxic nitrite is enhanced whilst the bacteria count in the water decreases, minimizing the risk of ill health in the animals. The compounds that produce yellow coloring in the aquarium are broken down and the water stays crystal clear. The ozone generators in the Ozone

    SKU: 202.20.
    Learn More
    $699.00

  8. Aqua Medic Ozone Booster ‐ Air Dryer

    Aqua Medic Ozone Booster ‐ Air Dryer

    The ozone booster is a media chamber filled with 1ltr of silicagel, for connection to an ozone generator. 
    Air is drawn through the ozone booster and any humidity is removed by the silicagel crystals before entering the ozonizer, resulting in a much higher ozone production. 
    The ozone booster can be fitted to the full range of Aqua Medic ozonizers as well as many other brands. 

    Dimensions: 
    Diameter: 80mm 
    Length: 240mm 
    Hose connection: 4/6mm

    Learn More
    $149.00

  9. Aqua Medic Silicagel – 1 ltr

    Aqua Medic Silicagel – 1 ltr.

    Silicagel – 1 ltr. Is a re-fill for our Ozone Booster. Silicagel is a dry granulate with high de-hydration capacity. The indication pearls changing color from blue to pink if wet.

    Learn More
    $19.90

  10. AquaForest CA Plus 150ml

    Component designed for supplementing iodine and fluorine in marine aquarium. It should be applied at least once a week in a dosage of 10 drops for 10l of aquarium water or 10ml (one top) for 200l (54 US gal.) of water – with average coral planting.
    US: 19 drops for 5 US gal. of aquarium water or 10ml (one cap) for 54 US gal. of water.

    Learn More
    $8.65

  11. AquaForest CA Plus 2000ml

    Component designed for supplementing iodine and fluorine in marine aquarium. It should be applied at least once a week in a dosage of 10 drops for 10l of aquarium water or 10ml (one top) for 200l (54 US gal.) of water – with average coral planting.
    US: 19 drops for 5 US gal. of aquarium water or 10ml (one cap) for 54 US gal. of water.

    Learn More
    $34.05

  12. AquaForest Carbon 1000ml

    High quality granulated active carbon. Eliminates undesirable chemical compounds in marine and freshwater aquariums. Carbon should be placed in flow filters in 100 ml for 100 l (27 US gal.) of water in marine aquarium or 200 l (54 US gal.)in freshwater aquarium.

    Recommended flow is maximum 500l/h through the media.

    The insert should be replaced every 4 weeks.

    Learn More
    $16.25

  13. AquaForest Carbon 5L

    High quality granulated active carbon. Eliminates undesirable chemical compounds in marine and freshwater aquariums. Carbon should be placed in flow filters in 100 ml for 100 l (27 US gal.) of water in marine aquarium or 200 l (54 US gal.)in freshwater aquarium.

    Recommended flow is maximum 500l/h through the media.

    The insert should be replaced every 4 weeks.

    Learn More
    $73.20

  14. AquaForest KH Plus 150ml

    Solution increasing temporary hardness level in marine aquariums. Application: 10ml of the solution increases KH level of 0,5°dKH in 100l of water. Maximum daily dosage is 20ml in 100l of water. Temporary hardness level in reef aquarium should be kept at around 6,5° – 8,0°dKH
    US: 2 tsp of the solution increases KH level of 0.5dKH in 27 US gal. of water. Maximum daily dosage is 4 tsp in 27 US gal. of water.

    Learn More
    $8.65

  15. AquaForest MG Plus 150ml

    Solution increasing magnesium level in marine aquariums. Application: 10ml of the solution increases Mg level of 5mg/l in 100l (27 US gal.) of water. Maximum daily dosage is 20ml in 100l of water. Magnesium level in reef aquarium should be kept at around 1300mg/l.

    Learn More
    $8.65

  16. AquaForest MG Plus 2000ml

    Solution increasing magnesium level in marine aquariums. Application: 10ml of the solution increases Mg level of 5mg/l in 100l (27 US gal.) of water. Maximum daily dosage is 20ml in 100l of water. Magnesium level in reef aquarium should be kept at around 1300mg/l.

    Learn More
    $34.05

  17. AquaForest AF Poly Glue 600g

    Polymer adhesive for corals.
    Usage: Glue granules should be placed in hot water (about 60ºC/ 140ºF); after a few minutes easily forming mass will create, which has the best adhesive properties. The adhesive will become completely solid when placed in the aquarium. We recommend that gluing process is performed out of the water. Coral can be placed in the water 30 seconds after bonding. Unused mass can be used again. Biodegradable product.

    Learn More
    $26.95

  18. AquaForest AF-110 Media Reactor 39cm High

    A fluidising reactor, intended for use with different types of filter media, It works perfectly as a reactor for Phosphate Absorbers, Activated Carbon and Zeolites. Thanks to the compact dimensions, it can be used both internally in the sump or externally. The Reactor is made entirely from high quality – 100% acrylic, making it resistant to damage and discolouration. We used a silicone seal which protects the filter against leakage. Inside the filter are sponges with a special fixture to prevent deformation of the internal sponge – it prevents also the passage of filter medium outside the filter housing (important in the case of resins or absorbers – like GFO). Important thing is also that our media reactors are very solid and nicely made. We recommend the use of 3 Aquaforest Media, Zeo Mix, Carbon and Phosphate Minus in combination.

    Diameter pipe: 110mm

    Height: 39cm

    Connections: 20mm

    Accommodates up to: 3L (6.34 US pt)

    The width of the cylinder: 15cm

    Learn More
    $159.25

  19. AquaForest AF-150 Media Reactor 45cm High

    A fluidising reactor, intended for use with different types of filter media, It works perfectly as a reactor for Phosphate Absorbers, Activated Carbon and Zeolites. Thanks to the compact dimensions, it can be used both internally in the sump or externally. The Reactor is made entirely from high quality – 100% acrylic, making it resistant to damage and discolouration. We used a silicone seal which protects the filter against leakage. Inside the filter are sponges with a special fixture to prevent deformation of the internal sponge – it prevents also the passage of filter medium outside the filter housing (important in the case of resins or absorbers – like GFO). Important thing is also that our media reactors are very solid and nicely made. We recommend the use of 3 Aquaforest Media, Zeo Mix, Carbon and Phosphate Minus in combination.

    Diameter pipe: 150mm

    Height: 45cm

    Connections: 20mm

    Accommodates up to: 7.2L (1.91 US gal)

    The width of the cylinder: 19cm

    Learn More
    $263.06

  20. AquaForest Component 1+ 2+ 3+ 15000ml (15L)

    Chemical composition of Component 1+2+3+ is based on the method developed by H. Balling. The formula has been fine tuned in our lab and enriched with trace elements that are fundamental for maintaining marine aquarium organisms in good form. As a result we have composed 3 fluids that are intended for dosing in equal amounts on regular basis. Component 1+2+3+ is designed to fulfil coral demands not only in terms of Magnesium and Calcium, but also in terms of other elements which require careful and systematic dosing, but are notoriously difficult to assess. In order to maintain adequate amount of trace elements in aquarium water, both Magnesium and Calcium levels need to be within recommended range (Ca 400-440 mg/L, Mg 1280-1350 mg/L) Typical aquarium with average number of hard corals requires approximately 50ml of each component per 100 l (27 US gal) of water daily. Dosage needs to be adjusted according to the consumption of macro-nutrients, and based on critical water parameters like Calcium, Magnesium and KH. If one or two parameters are still not balanced- we recommend to continue with administering equal doses of each component, and take advantage of one of our additives (Calcium, Magnesium, KH Buffer) to restore desired level(s).

    Learn More
    $63.12

Items 1 to 20 of 732 total

Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

List  Grid 

Set Descending Direction